Replacing the bearings in the Dodge Caliber generator

To replace the bearings in the generator, you must do the following: The key is to roll eight long bolts that hold the generator. Smash the top cover with the rotor. You can remove the back little bearing from the front cover. Press the rotor out of the front cover and remove the rotor from the front cover. at the same time inserting the wire into the hole in the back cover. The rear cover, the rear cover, the front and the four bolts, the wire.

1. The key to eight is to spin eight long bolts that pull the generator.
2. hammer the top cover with the rotor.
3. Special tenants for bearings to remove the rear little bearings.
4. Squeal the rotor into the clutches and unscrew the muff.
5. To be selected using the rotor's hammer from the front cover.
6. A strong screwdriver to remove the four screws, remove the front bearings cover, and dislodge it.
7. Install the new cover and cover.
8. Slight the hammer to install the rear bearings.
9. Insert the rotor axis into the front cover.
10. At the same time, at the same time, insert the wire into the hole in the back cover.
11. To remove the back cover, align it with the front and pin the four bolts.
12. Roll a muff.

bearings:

Front:

• PN16-18-W27 (Mazda)
• AS-6303-2RS (Feb.)
• B30200 (Seijiku)

Rear:

• N336-18-W36 (Mazda)

Add comment