To replace the introduction of the belt and the first generation BMW of the first generation, do the following: The key of the T20 TORS is the two screws to the air intakes and remove the head "by 16" and put it on the caster bolt. You can rotate the video clip with the help of a swirl with the help of a 3-4 millimetre swirl. We're rolling out the wheel-roll. We're rolling out the clip. We're going to make a new video and wait for 40 Nm. Put a new belt on all of the pullees. We put the belt on for the last time. Check the installation and put the air intake back in place.
- The key of the TORS T-20 shall be taken to unscrew the two screws to the inlet of the air inlet and remove it.
- We take the head "on 16" and put it on the caster bolt. It is more convenient to keep the clip from a swirl with the help of a 3-4 mm (6-inch) swirl.
- We're taking this belt off.
- The "16" is the end of the clip.
- We shall install a new ad and delay it by 40 Nm.
- Put your new belt on all the pullees. We put the belt on for the last time.
- Check the installation and put the air intake back in place.
