Replacement of the steering gear on the Audi 100 C4

To change the arrowheads of transverse helmsman for Audi 100 C4, do the following: We turn the wheel off. We pull out the self-contained nut in the wheelhouse. We pull the knobhead from the lever with the lift. We wind it up with the tip. Let' s celebrate the tip of the tip. We twist the tip by counting the number of turns. We put in a new tip, spin it at the same speed. We're checking the installation marks.

1. We're rolling the wheel.
2. Scrolling the self-driving nut in the wheelhouse.
3. pull the spout out of the lever with the lift.
4. A holding bolt, swinging a counter-nut to drive.
5. We note the position of the nozzle.
6. Scrolling the nozzle, counting the revolutions.
7. Let' s put on a new tip, spin it on the same speed. Verifying the installation label.
8. Enchanking the arrowheads to the lever.
9. A new self-fighting nut and tighten it at 50 Nm.
10. We tighten the contour nuts at 50 Nm, and we ensure that the tips are not strapped to the side.
11. Checking the ascent.

Add comment