Adjusting the rear foot bearings on the Audi 100 C4

It is only possible to change the back-level bearings of the back-hub bearings of the Aodi 100 4th generation. To do this: Lift the rear of the vehicle and remove the wheel cap from the bearings of the hub. If the swiftee is right, then the hard washer can be moved slightly by a small screwdriver by a screwdriver.

1. Let' s get the back of the car.
2. We remove the wheel cap and pull the plow from the hub bearings.
3. Press the screw hole to the top of the adjustment valve.
4. Lightly tighten the hexagonal nut, scroll the wheel.
5. A little bit of a nut. If the swiftball is correct, a hard washer for the nut can be slightly moved by a small screwdriver.
6. Put on a table splint and put on a wheel cap.

Add comment