To remove the front berm on Mazda 3 (I), you must: Remove the brakes of the anti-lock braking system. Remove the tip of the steering gear and the lower back lever with the help of a special device. Then remove the rear brake mechanism and draw it on the wire. Set up the outer diameter of the semi-centreline. After the installation, measure the outer diameter which must be 31.2 mm maximum. If the normal is exceeded, repeat Install using a new clip.
- The oil from the checkpoint.
- Then remove the anti-lock sensor system.
- Remove the ball cap of the tip of the steering gear and the joint of the lower back lever by means of a special device.
- Then remove the rear braking mechanism's sub-port and weigh it on the wire.
- You pull the connecting shaft straight.
- Set up a special device to hold the semiaxial gear.
- Before you install, put the new clip up with the new clip.
- After installation, measure the outer diameter of 31.2 mm maximum.
- If the rule is exceeded, repeat the installation using the new clip.