Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 11 January 2022

The fully folded back seat of Peugeot 207 forms a single plane with the luggage compartment floor. To add it, you must: 1. Pull up the forward edge of the seat cushion to the top of the bottom of the latch.

Details

Written by: Jason Hance

Also available:

Created: 10 January 2022

The demonstration of the interior lining of doors in Peugeot 207 is proceeding as follows: 1.     Remove the 2 mounting screws located at the top of the front and back end of the door. 2. Remove the securing screw on the windshield control panel.

Details

Written by: Jason Hance

Also available:

Created: 10 January 2022

A flashing temperature indicator in Peugeot 207 is used to warn the driver of risk of ice. The temperature range from -3 to + 3 °C gives a sound signal, the Ice alert or the Risk of ice message appears on the display, and the temperature indication is beginning to blink

Details

Written by: Jason Hance

Also available:

Created: 09 January 2022

To reset the interservice interval count to Peugeot 207, you must do the following: 1. Turn off the ignition; 2. Press and hold the diem button of odometer; 3. Ignition start 4

Details

Written by: Jason Hance

Also available:

Created: 08 January 2022

This service message on the Peugeot 207 display indicates a malfunction or breakdown of the oil level sensor chain

Details

Written by: Jason Hance

Also available:

Created: 07 January 2022

The problem with the heating of the seats may be due to the closure of the relays installed under the seat and responsible for the operation of the Peugeot 207 heating system

Details

Written by: Jason Hance

Also available:

Created: 07 January 2022

After replacing the magnets in Peugeot 207, the nonpermanent owners often encounter the inability to adjust the time on the display. After replacing a permanent magnet, the time adjustment is only possible with a diagnostic scanner

Details

Written by: Jason Hance

Also available:

Created: 06 January 2022

Sufficient and common problem for Peugeot 207 is the message "Direction indicators fault" when the indicator lamps are operating normally. This is often the case with an unconnected alarm connection

Details

Written by: Jason Hance

Also available:

Created: 05 January 2022

Peugeot's salon 207 very often appears "cricket" and other extraneous sounds. One of the most common creaking sources in Peugeot 207 is the brake pedal, which makes sound every time

Details

Written by: Jason Hance

Also available:

Created: 05 January 2022

Generally, a source of disagreeable sounds in the Peugeot 207 salon is the frame of deflection unit. They are removed by a special tenant, but can be replaced by a thin-blade screwdriver, wrapped cloth, or a plastic card