Vehicle interior

The fan is woven at Opel Corsa D

The fan is woven at Opel Corsa D
Generally, the fan of the cabin in the Opel Corsa D begins to whistle when the first fan speed is turned on. If the car is under warranty, the motor of the fan can be replaced by a dealer

The [ [ Opel Corsa D]]'s [ [ Opel Corsa D]]

The [ [ Opel Corsa D]]'s [ [ Opel Corsa D]]
Many owners of the [ [ Opel Corsa D]] collide with the [ [ water]] during the rain from under the glove box

The Opel Corsa D fan works only in the "4" position

Many Opel Corsa D breaks the resistor of the heater. In general, the resistor fuse is out of order. The replacement of the resistor is between 1500 and 3000 rubles. However, before you buy a new resistor, it is recommended that you check the reliability of the wiring connector for the wiring

Opel Vectra C

Opel Vectra C
The special features of the magnet on the Opel Vektra C:-If you press the magnet down arrow, then RONOM will appear and the songs from the disc will be played in random order

Removing the front door on Peugeot 206

Removing the front door on Peugeot 206
To remove the Peugeot 206 front door, perform the following steps: the Torx wrench to spin three bolts of the binder. The first one is in the cavalation of the plastic arm of the arm

Removing the Peugeot 206

Removing the Peugeot 206
In the four corners of the body of the Peugeot 206, there are holes for its dismantling. In order to remove the magnets, it is necessary to insert sharp objects into these holes, for example, the spokes. Next, you need to pick up the edge of the shell with a thin screwdriver and pull it on yourself.

Which maximum column size can be installed in the Peugeot 206 salon instead of the staff

Which maximum column size can be installed in the Peugeot 206 salon instead of the staff
The diameter of the landing hole for speakers in the front door Peugeot 206 is 16.5 centimeters. The size of the speakers is 4.5 centimeters. Columns have been laid with powder thickness of about 2 centimeters thick

Fuel level sensor on Peugeot 206

Fuel level sensor on Peugeot 206
Many of the owners of Peugeot 206 complain about the incorrect operation of the fuel level sensor. Most of the time, the Peugeot 206 fuel level sensor is "lying" in two cases: if the Peugeot 206 fuel tank runs "blindfold", if the vehicle refuelling occurs with the ignition on.

The Peugeot 206 switch switch is broken.

The Peugeot 206 switch switch is broken.
One of the typical problems in Peugeot 206 is a complete or partial failure of the signal switch. This is about the weak attachment of the rotation lever in the unit of switches. Either the entire block is being replaced, or the problem is broken down and the attachment is repaired

Peugeot 206

Peugeot 206
Peugeot 206 is the most common result of the reduction of the docking stitch between the two lead-in heaters that pass close to the accelerator pedal