Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 18 October 2021

The failure to control air flows is caused by the failure of the corresponding drive. It is located on the left side of the heater. To correct the problem, remove the lower torpedo panel from the driver's side and remove the actuator (hold on the screws)

Details

Written by: Jason Hance

Also available:

Created: 17 October 2021

If the air temperature of the air conditioner and the air conditioner is not regulated in all modes (manual and automatic), the reason is the fault of the mixing of air flows

Details

Written by: Jason Hance

Also available:

Created: 17 October 2021

A very active antenna is installed on the vehicle, but it does not always provide a secure radio station, especially in the city. The main reason is the low quality of the antenna, the problem can be solved by installing a new antenna

Details

Written by: Jason Hance

Also available:

Created: 16 October 2021

The deep non-metallic knock in the area of the left leg of the driver, under the dash, arises from the design of the car. This problem is not solved by all SsangYong Kyron, it is not possible to solve this problem

Details

Written by: Jason Hance

Also available:

Created: 15 October 2021

The crypto torpedo is localized in several places: through the contact of plastic panels in the area of the installation of the magnetola, in the place of [ [ torpedo]] in the [ [ windshield]] and in others

Details

Written by: Jason Hance

Also available:

Created: 14 October 2021

The column filter is located behind the glove box, which makes it difficult to access it

Details

Written by: Jason Hance

Also available:

Created: 14 October 2021

As in any other car, in Suzuki Grand Vitar of the 2nd generation, "crictions" appear sooner or later, which bring many problems to drivers. One of the most common occurrences of "cricket" and creaking in Suzuki Grand Vitara II is the driver's seat

Details

Written by: Jason Hance

Also available:

Created: 13 October 2021

For the lubrication and cleaning of the fan heater, Suzuki Grand Vitara II must first remove the glove box and the lid, which is located under the feet of the passenger, under the glove compartment. Remove the fan connector from the fan. Remove the corrugated tube from the stove

Details

Written by: Jason Hance

Also available:

Created: 12 October 2021

Removal of the Suzuki Grand Vitara II door is best started by removing the corner of the mirror with the speaker that you just need to pull out. I'm going to sink a central part of the clip and get it out. Get the door-pocket stub and roll it off.

Details

Written by: Jason Hance

Also available:

Created: 12 October 2021

To remove the back door, Suzuki Grand Vitara II will need two flat-blade screwdrivers: thin and long. First we need to remove the linings under the glass, which is fixed on the four clips.