Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 25 October 2021

Vehicles with small turbo motors are slowly warmed up. For Yeti to warm up faster, you need to start the engine, turn on the dipped-beam, and all the heaters, but turn off the heater completely

Details

Written by: Jason Hance

Also available:

Created: 24 October 2021

One of the common problems of Yeti is a poorly functioning fuel level indicator. As a rule, the arrow is lowered to zero, with any quantity of fuel in the fuel tank

Details

Written by: Jason Hance

Also available:

Created: 24 October 2021

You can retrieve a central air duct to install a multimedia system or a GPS receiver. It's not that easy to disassemble. To do this, you will have to make a tenant that looks like a long thin screwdriver with a solid hook at the end

Details

Written by: Jason Hance

Also available:

Created: 23 October 2021

Already at the beginning of exploitation on Yeti starts to tap a niche for storage located under the climate control block. The reason for the sound is that the niche is fixed at the bottom of the two screws hidden under the plastic lining of the gearbox, and the top is mounted by the two screws

Details

Written by: Jason Hance

Also available:

Created: 22 October 2021

Some Picking features of the Yeti code provide a special box under the seat for storing things. However, if there is no such box in Skoda Yeti, it can be ordered and installed independently

Details

Written by: Jason Hance

Also available:

Created: 21 October 2021

You can replace the pedal pedal with the Yeti with the pedal with the more expensive versions of the model. The first thing you need to do is twist two screws on the plastic cover and remove it. Then we need to remove the screw into the pedal.

Details

Written by: Jason Hance

Also available:

Created: 21 October 2021

You need to turn off the ignition first, otherwise you will receive an error that you can only erase on the service. To unplug the airbag, you must use a screwdriver to detach the connector from the rear

Details

Written by: Jason Hance

Also available:

Created: 20 October 2021

If you have a Bolero multimedia system, you can test the performance of the antenna yourself. To do this, in the radio mode, you must press the Setup button and hold it in the pressed position for two seconds

Details

Written by: Jason Hance

Also available:

Created: 19 October 2021

The removal of the front doors is done as follows: Unscrew the screws on the plating perimeter (only seven pieces); Disconnect all the electrical connectors and ropes of the door handle; gently pull the plating on itself and then up-it shall be easily removed

Details

Written by: Jason Hance

Also available:

Created: 19 October 2021

The car is equipped with a permanent magnet (parent) of the size 2DIN, which is equipped with a sensory display, but it is not difficult to replace it if desired