Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 04 October 2021

Adjust the height of the brake pedal to Toyota Avensis 2. To do this: Take off the floor mat. For machines with ICPC, it must be 148...158 mm, for models with ACPR-150...160 mm. Remove the lower trim panel. Disconnect the stop-stop-switch connector

Details

Written by: Jason Hance

Also available:

Created: 03 October 2021

One of the weaknesses of the second generation of Toyota Avensis is the opening mechanism of the central box, which can easily break. Repair of the mechanism is done by Rs. 2 screws and remove the box

Details

Written by: Jason Hance

Also available:

Created: 02 October 2021

The common problem on Toyota Avensis is the noise that is heard in the area of the front passenger's legs. The reason is that the servo power of the heater is not functioning correctly. The problem is that we're taking off the glove box. We're taking off the bar below the glove box.

Details

Written by: Jason Hance

Also available:

Created: 02 October 2021

The following information may be displayed on the Toliota Avensis 2 display: RANGE button; distance after engine start-DISTANCE/REROUTE; Avg avt-button Av.SPD/BACK; Average fuel consumption since previous fill-AV button

Details

Written by: Jason Hance

Also available:

Created: 01 October 2021

On the dashboard of Toyota Avensis 2 there are two indicators to report the state of the lubricant: Just the oil. The signal warns of low pressure in the lubrication system

Details

Written by: Jason Hance

Also available:

Created: 30 September 2021

The replacement of the salon filter on Toyota Avensis 2 is desirable once every six months. It's like this: Open the glove box and screw the two screws on each side. We press the glove box inside to free it from the latches.

Details

Written by: Jason Hance

Also available:

Created: 30 September 2021

In order to verify this function of the Toyota Camry VII, it is necessary to send any light source on the mirror, preclosing the luminance sensor-the mirror must be darkened. After that, a light intensity sensor is to be opened

Details

Written by: Jason Hance

Also available:

Created: 29 September 2021

The light control unit is located in the front of the passenger compartment. The unit itself is a circuit board with wires in the tequier. It is necessary to find two wires-white and black, clean them, not cut them, connect them with future backlight

Details

Written by: Jason Hance

Also available:

Created: 28 September 2021

In order to dismantle the door cladding on the Toyota Camry VII, it is necessary to do the following:-remove the gladders and the filler handle. They shall be removed easily-it is sufficient to make a sharp object

Details

Written by: Jason Hance

Also available:

Created: 27 September 2021

To replace the salon filter, you must open the original crate, release the absorbent holder, and release the retainers to the bottom of the cover. This will open the filter stub (white)