Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 13 September 2021

The laying of the third row of seats on the Toyota Land Cruiser 200 is carried out in this sequence: (1) Shrling downwards the head restraint by pulling the seat controls of the third row by pressing on the tilt control levers.

Details

Written by: Jason Hance

Also available:

Created: 12 September 2021

As the Toyota Land Cruiser 200 is very large, it needs constant work of air conditioning. As a result, even the small pollution of the air-conditioner heat radiator causes the refrigerant temperature increase and the compressor's overheating

Details

Written by: Jason Hance

Also available:

Created: 11 September 2021

The engine preheat system at the Toyota Land Cruiser 200 is connected to the liquid contour of the cooling system between the motor and the front pastry of the passenger compartment. The heater unit itself is placed in the front bumper cavity near the right foot

Details

Written by: Jason Hance

Also available:

Created: 10 September 2021

To clean or replace the air conditioner filter on TOYOTOTA LAND CRUISER 200 must do this: 1) Turn on the IGNITION ON mode and start the recycling mode 2. Turn off the ignition. 3) Open the tip box and remove it from the partition

Details

Written by: Jason Hance

Also available:

Created: 10 September 2021

To activate the cruise control on Prius, you must press the button on the lever to catch the Cruise lamp. At least 60 \   km/h (European and American versions) or 40 km/h (Japanese versions) are required and the lever is pressed down

Details

Written by: Jason Hance

Also available:

Created: 09 September 2021

Configure Bluetooth on a Prius designed for the European or American market (left handlebar) simply because all buttons have receipts. In Japanese versions, all the characters are hieroglyphics

Details

Written by: Jason Hance

Also available:

Created: 08 September 2021

Toyota Prius, like many other cars, has a built-in self-diagnosis system that can be activated in a variety of ways. The first is to retrace the contact l-line and Signal Ground in the diagnostic connector

Details

Written by: Jason Hance

Also available:

Created: 08 September 2021

It is not difficult to disassemble the central console on Prius. The first thing you need to do is pull the driver's drive. We need to drive two self-carts, spin them. Remove the bar underneath the wheel, and then take the bezel off the wheel

Details

Written by: Jason Hance

Also available:

Created: 07 September 2021

To delete the "MAINT REQD" message, you must first determine which statement issues the odometer on the board. It should display the total mileage of the car

Details

Written by: Jason Hance

Also available:

Created: 06 September 2021

The number of the Toyota Prius salon filter order for the order-87139-47010-831st case needs to be opened.