Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 22 August 2021

One of the most common places of "cricket" in the salon Volkswagen Passat seventh generation is the central pillar. The most commonly used violin in the Volkswagen Passat B7 appears in the area of the safety-belt mechanism

Details

Written by: Jason Hance

Also available:

Created: 22 August 2021

Yeah, it's possible. To do this, you need to enter the long-term information mode of the onboard computer and press and hold the OK button for 2-3 seconds

Details

Written by: Jason Hance

Also available:

Created: 21 August 2021

The visions are better off together with the breakers. The leaves are bolted to the floor with four "asterisk" bolts. A corresponding screwdriver will be needed to unwind them. Under the seat, disconnect all wires so that they do not damage them.

Details

Written by: Jason Hance

Also available:

Created: 20 August 2021

It is possible that the nozzle of the air ducts is cluttered and placed under the front seats. The vehicle mat can interfere with the free passage of air

Details

Written by: Jason Hance

Also available:

Created: 19 August 2021

The light can flash when the lock is not in control or the entire lock must be changed by the guarantee. Also, the service should check the wiring of the sensor under the seat, possibly disengaging contacts

Details

Written by: Jason Hance

Also available:

Created: 19 August 2021

"Cricket" in Polo Sedan salon long ago discovered by attentive drivers

Details

Written by: Jason Hance

Also available:

Created: 18 August 2021

If there is water in the salon after the rain, perhaps the reason for the clogging of the water hole in the toad. There could be mud, topy fluff, small leaves.

Details

Written by: Jason Hance

Also available:

Created: 17 August 2021

Depending on the configuration, the Volkswagen Tiguang car is equipped with a normal steering wheel or a multi-wheel drive with functional buttons. The buttons on the handlebars allow you to navigate the menu of the onboard computer

Details

Written by: Jason Hance

Also available:

Created: 17 August 2021

To do this, you must press and hold the reset button (0.0) on the dash, and then enable the ignition, release the reset button, and then press the minute button (min). A special cable may be purchased for the same purpose

Details

Written by: Jason Hance

Also available:

Created: 16 August 2021

It is important to remove the key from the ignition key before it is run. Remove: click off the side bar (which is to the right of the glove box), turn off the two lower Sámi, first on the left, then on the right, turn on the three saloes from the top, hook up, and pull the backlight