To replace the heater heater radiator for the fourth generation of the fourth generation without a climate installation, you will need a set of screwup, peat, and fatty keys "by 8" and "by 10", a key "on 13", a sealant, and a sealant. Replacement procedure:
- Move the front seats forward as fast as possible.
- Scroll down the two sides of the central console.
- Unfastening the filler, unscrew the two deflection units.
- On the other hand, you can unroll another sailor's anchorage.
- Disconnect the deflection unit connector, remove the deflectors.
- Remove the lining from the parking brake.
- Roll the checkpoint on the checkpoint and take off his cover.
- Under the cover, two screws to the console.
- Capture the handbrake, turn on 3, and remove the console.
- Remove the controls of the heater and remove the screws below them.
- Scroll down four bolts.
- Remove the ashtray.
- Carefully use the screwdriver to remove central deflectors.
- Detach the heater lateral bolts.
- Remove the side-clips under the deflection units and unscrew one bolt from each side.
- At the foot of the pedals, remove the seal of the central console and unscrew the nut clip.
- Pull back and remove the central console.
- Remove the head device.
- Disconnect the heater connectors.
- Disconnect the connector on the tunnel.
- Remove the anchorage between the seats and remove the air duct.
- Remove the glove box.
- Unlock five bolts and remove the original box under the handlebars.
- Detach the anchorages and remove the ducts from the driving and passenger side.
- Detach the G-duct ducts
- Under the hood, remove the plastic protection in front of the wipers.
- Remove the wipers.
- Detach the fastenings and remove the pad under the windshield.
- Detach the fastenings, disconnect the connectors, and remove the caretators.
- Disconnect the hoses from the heater. It's about a quart of antifreeze.
- Heal heater.
- Cuts the bolts and disassemble the heater into two halves.
- Change the heat sink and set it all back.