- Details
-
January 03, 2023
-
Written by Jason Hance
First, you need to unscrew the large thumbscrew and release the two latches in the rear of the vehicle. Now we need to pull the headlights up and up. On the reverse side of the lamp, there is a cover on the latches. This should be removed.
- Details
-
January 02, 2023
-
Written by Jason Hance
The second generation Hocus has two fuse blocks. One is located in the salon and the other in a subspace. To access the fuse box of the fuses, the two screws at the lower right of the instrument panel are required
- Details
-
January 02, 2023
-
Written by Jason Hance
The Kia Sportage III fuse is nonstandard. Emergency fuse must be in the fuse box under the bonnet
- Details
-
January 01, 2023
-
Written by Jason Hance
The rear lamps are most likely to warm up on the hatchback. The peculiarity of their construction is that it is not possible to drain the entire internal surface of the lantern in the raw weather due to this lamp
- Details
-
January 01, 2023
-
Written by Jason Hance
The amber light indicator shall be activated when there is a danger of the presence of a lady on the roads. The red snowflake becomes the temperature of the air. The inclusion of "snowflakes" is accompanied by an audible signal
- Details
-
December 31, 2022
-
Written by Jason Hance
It is included by the Climate Control button (rear). This button is responsible for heating the windscreen in the brush area, heating the rear window and heating the side mirrors. After a few minutes after heating (about 3 minutes), you can turn on the wipers
- Details
-
December 31, 2022
-
Written by Jason Hance
The replacement of the driving beam and the dipped-beam in Fusion will take time. You need to open the hood and find the rubber lid for the faro. The lid needs to be removed. Then, disconnect all cables leading to the headlamp. In the headlamp the lamp is held with spring wire
- Details
-
December 30, 2022
-
Written by Jason Hance
It is very simple to replace the lamp in the direction indicator on the front of the Fusion, but proceed with caution. It's gonna need a facial screwdriver and a soft cloth. The ripper needs to wrap the end of the screwdriver to avoid damaging the wing
- Details
-
December 30, 2022
-
Written by Jason Hance
In order to replace the light bulb on Sportage 3, it is necessary to looses the mounting bolts and remove the headlamp from the body of the car. Then, unscrew the round cover from the rear of the lamp, remove the lamp from the lamp, release the light bulbs and remove the bulb
- Details
-
December 30, 2022
-
Written by Jason Hance
To replace the lamp in the rear lamp, it is necessary to open the luggage door and twist the two carrots that hold the lamps. After that, you need to turn the nut clip off. She's on the level of the hook.