- Details
-
January 23, 2023
-
Written by Jason Hance
Front headlights Ford Focus 3 is a non-latrine, and the manufacturer does not recommend that they be dismantled. However, some of the beetles do understand the headlight of Ford Focus 3 using either a hairdryer or a blown-up knife (and especially daring even try to heat the headlight in the oven!)
- Details
-
January 23, 2023
-
Written by Jason Hance
To replace the front fog lamp and rear door lamp in the Kia Serato 2, open the trunk lid, looser the bolt, secure the cover to open the lamp, and remove the cover
- Details
-
January 23, 2023
-
Written by Jason Hance
The cleaning fluid level sensor is only installed when ordering the "Premium-Light" options. The sensor installation will require a new abluer tank, sensor, and wiring. Not only will it be necessary to install, but also to sew the new function in the onboard computer
- Details
-
January 22, 2023
-
Written by Jason Hance
The user's guide Focus 2 allows the engine to be started by means of wires from another vehicle. The inverse operation is also valid
- Details
-
January 22, 2023
-
Written by Jason Hance
This function is designed to prevent battery discharge in KIA Rio III. The system automatically shuts off the outdoor lighting when the driver pulls the key from the ignition (stop the engine with the electronic key) and opens the door for his or her part
- Details
-
January 21, 2023
-
Written by Jason Hance
If the problem is not in the light bulb, then the wiring or oxidation is most likely to rot. This is a common problem, as the lamps are under the bumper. Another possible problem of failure of the rear fog lamp is its meltdown
- Details
-
January 21, 2023
-
Written by Jason Hance
The most likely cause is a problem with the transaction. You need to check the connector under the driver's seat. If the connector is properly connected and the contacts are in order, you need to verify the rest of the alarm transaction
- Details
-
January 20, 2023
-
Written by Jason Hance
To replace the passing lamp in Kiia Río 3, the following steps must be taken: 1. Rotate the shell counterclockwise at the rear of the headlamp 2. Disconnect the connector from the headlight by pushing the connector and pulling it back 3
- Details
-
January 20, 2023
-
Written by Jason Hance
The heating of the windshield is no longer working because of the oxidation of the contacts in the relay, or because of the overheating of the heating threads. The line break is causing cracks. The break can result in a shutdown of both parts and whole glass
- Details
-
January 19, 2023
-
Written by Jason Hance
The first generation of the Fokus is often a failure or a bad sound. This is related to the failure of the speaker: often moisture and dirt fall on it