- Details
-
January 28, 2023
-
Written by Jason Hance
The "Scandinavian Light" functions are the automatic activation and deactivation of the dipped-beam headlamps when the engine is started and shut down. If a 3-position light control unit is installed in the vehicle, remove the unit
- Details
-
January 27, 2023
-
Written by Jason Hance
Sometimes it is necessary to turn off the power of the car for some time to eliminate electronics errors. To do this, you need to disable the battery
- Details
-
January 27, 2023
-
Written by Jason Hance
We need to open the trunk and find the trapezodier lid inside the trunk, behind the unit on the wing. The lid needs to be opened. Plastic fillers are placed under the cover to turn the attention to the clockwise direction and retrieve
- Details
-
January 26, 2023
-
Written by Jason Hance
The first thing to do is to lower the steering wheel. Then remove the top cover of the steering column and rotate the two carropes (torx, star). Next, remove the bottom cover of the steering column and place the rudder down until it is fully down
- Details
-
January 26, 2023
-
Written by Jason Hance
It is necessary to open the hood and rotate the two bolts, holding the headlight, and then gently pull it onto itself. Then, disconnect the main connector with the wiring, touching it with a flat-blade screwdriver in a specially designed location. Now the headlamp can be extracted.
- Details
-
January 25, 2023
-
Written by Jason Hance
Before you start, you should make sure that the light in your car is turned off. For more safety, you can unplug a minute tick from the battery .The first thing to do is to separate the lamp-lamp from its hull, with the flat-blade screwdriver
- Details
-
January 25, 2023
-
Written by Jason Hance
After you turn off the battery, you need to restore the window-lift algorithm to the beginning of the battery. Then, hold down the key and release it when the glass is completely closed
- Details
-
January 24, 2023
-
Written by Jason Hance
The Ford Focus 3 is installed as a headlamp with a lens (halogen) and a headlamp with a lens (xenon). Lamps for these headlamps are different. For headlamps with a lens: H7-passing beam, H1-driving beam
- Details
-
January 24, 2023
-
Written by Jason Hance
The Kia Cerato 2 lamps in the front lamps are burned quite often. To remove them, remove the headlamp. It's not hard to do. Just open the hood and spin two bolts, holding the headlight. They are located on top of the lamp, on the edges
- Details
-
January 24, 2023
-
Written by Jason Hance
The blinking of LED day headlights built into the headlamp is a common problem for the third generation Focus. The defect is most often expressed in cold weather or when the vehicle is launched. Dealers accept the warranty and change the headlamps for free