Electrical equipment

The first thing you need to do is twist a Soresis with a blinker, and remove the blinker and grille of the radiator that's holding on three smores. The upper bolts of the headlamp may then be turned off. There are two other bolts from the front of the lamp, which also need to be removed

If the illumination of the heater unit has ceased to work on the Jeep Grand Cheroki WK, then the lights need to be replaced. To do this: Buy 5 light bulbs 12 V for illuminating devices. Pull the chrome bar near the CPP. Take off the center panel

On the updated Nexia, the headlights are much more complicated. Sometimes it is necessary to remove the bumper, since one of the mounting bolts is behind it. However, there is a way to remove the headlamp without dismantling the bumper. The first thing to do is to unscrew all the available fastening bolts

The first thing to do is to snapped the triangular plastic lining of the rearview mirror and remove it with the seal

Often the owners of Kiia Sid 2 encounter the failure of the Magnetoloi buttons. This problem is caused by the break-down of the contact ring. It is worth to ask the dealer-such cases are the guaranes

First of all, it is necessary to remove the lining of the steering column and the lining of the instrument panel. The masonas are held on two mores located behind the wheel. To make them more comfortable, you have to turn the steering wheel first into one side and then turn it into another 90 degrees

The lifting of the fog lamp may be necessary to replace the lamp (with the installed lift practically impossible) or for repair. The first thing to do is to trim the outside plastic lining of the flat-blade screwdriver and remove it.

The part of the unpleasant situation on the Kiya Sid is connected with the use of low-quality plastic, if the assembly of the master too fastening the fastenings-the quick cracks are secured. Plophone should be replaced by warrants

The most common problem for the misfire of the Necsiah is the failure of the contact group. To remove the ignition locking system, remove the cover on the 4-axis, remove the protective and decorative ring from the ignition lock

If the reversing lamp on the Necsiah stopped turning on when the rear gear was switched on, the problem is most likely in the switch, in the people called the "frog". To replace it, you must first disable the electrical connector