Electrical equipment

In order to replace the yellow lights of the Citroen C4 light on the LED, it is necessary to remove the front flaw from the socket.

To program individual settings in the onboard computer, Jeep Grand Cherokee WK2 needs to put the selector lever in position R. You can then use the up/down arrow buttons to select and configure the function: Selecting a language

To replace the passing lamp with a Citroen C4 car, it is necessary to open the bonnet and remove the rubber stub from the rear of the headlamp. Then, remove the two nut-screw lock anchors and detach the pad with the wires suitable for the lamp.

To replace the stop-lamp in the unit of Citroen P4, it is necessary to remove the unit-headlamp (remove the two beers from the inside, tray the centre of the unit and remove it before the limiter).Next unscrew the plastic bolt under the upholstery

Problems with electronic systems Jeep Grand Cheroki WK are usually limited to minor problems, which can be attributed to the self-arbitrary inclusion of various alarm signals. For 3 to 4 years of operation, the air pressure transducers in the width usually come out of order

In order to replace the Citroen C4 front fog lamp, three piles of lower bumper and a 10-foot bolt are needed to remove the pistons of the pistons.

The procedure for replacing the rear lamp Citroen C4 needs to start with the definition of a lamp that needs to be replaced-left or right. Next, open the trunk, find three plastic clips on the side of the lamp, and disconnect them

To connect the trailer to the onboard power grid Jeep Grand Cheroki WK uses 7-pin AUV connector: 1 (left indicator)-yellow wire

To start a Citroen C4 from a third battery, you need to access the battery (hereafter referred to as the "A") of the car that is located under the hood.

Before you begin, you must disconnect the battery minus. After that, you have to remove the caretapy and cover the panel. Next, it is necessary to separate the ball connection with the stroke of the janet and the motor