- Details
-
February 13, 2023
-
Written by Jason Hance
If the front headlights on the Kia Cerato 2 start to warm up too much, the following simple actions must be performed: 1. Open the hood 2. Uncover the internal side of the headlamp to cover the lights. Insert a passing beam and a driving beam. 4. Wait until the lights are completely asleep.
- Details
-
February 13, 2023
-
Written by Jason Hance
If the Necsiya stops beeping, the first thing you need to do is check the integrity of the transaction. If it's all right with the wiring, you need to remove the snail from the horn and disassemble it with six screws. Inside is likely to be rust, including contacts
- Details
-
February 12, 2023
-
Written by Jason Hance
The proofreader is reconfiguring the engine's electronic engine control unit for the use of petrol with a specific octane number. The proofreader is sometimes referred to as a "chip". It can be purchased at the spare parts store
- Details
-
February 12, 2023
-
Written by Jason Hance
To dismantle the antenna on the Kia Cerato 2 roof, you need to do the following: 1. Open the back door 2. Dismount the rear frame plating with your fingers and pulling on 3. Retration of the ceiling to allow access to the antenna
- Details
-
February 12, 2023
-
Written by Jason Hance
The first thing to do is to remove the headlamp: it is not convenient to remove the glass from the installed headlight, and you can damage the LCP. A hairdryer that can heat up to 300 and 500 degrees is needed to remove the glass. It will also require a flat, thin screwdriver
- Details
-
February 11, 2023
-
Written by Jason Hance
If Nekness does not start in the cold weather, the engine "three" and the exhaust pipe are black smoke, there is a high probability that there are problems with the absolute pressure sensor (DAD). It is likely to have condensation formed due to temperature changes
- Details
-
February 11, 2023
-
Written by Jason Hance
The angle of the beam can be adjusted by a proofreader from the passenger compartment. However, if the angle is lost and one of the headlamps is too low or too high, the angle of the beam can be adjusted manually on each headlamp
- Details
-
February 10, 2023
-
Written by Jason Hance
The fuel level sensor at Necsiya often shows incorrect information. Also, the dashboard may display correct information, but it will burn low fuel in the tank
- Details
-
February 10, 2023
-
Written by Jason Hance
Some of the excisions were equipped with a pull-out antenna, which resulted in an electric motor. The top of the antenna is the first symptom of the malfunction. The first thing to do is take off the antenna, unscrew one nut out on 17 and two inside 10.
- Details
-
February 09, 2023
-
Written by Jason Hance
If a cleaning fluid level sensor is not installed on the vehicle, it can be installed on its own. The operation will require a cleaning fluid level sensor and a sealing ring for it, a connector from the back of Lada Kalina, about 4 meters