Electrical equipment

Before you start, you need to disconnect the battery minus, lift your car, and remove the front wheels (if you have two jacks, you can start at one end, then on the other side)

Before you begin, you must disconnect the battery minus. Then we'll have to remove the front bumper. Next, you need to twist the only screw that holds the blinker, turn off the power connector, and remove the blinker

In order to automatically lock the WK2's Jeep-Cherokki doors above about 25 km/h, you can do the following: Open the car, sit down and close the doors.

Before you begin, you must disconnect the battery minus. Next, the luggage door shall be opened and the shell shall be removed from the wing on the side where the lantern will be removed

First, you need to disconnect the battery minus. Then it is necessary to unroll the two carrots, which are located on the edge of the plateau, to pull out the plaid. The lamp will be visible behind the plaid, and it needs to be pulled over

The WK2 Jeep Grand Cherokee has been integrated, but the opening function of the trunk door has not been activated. To turn it on, we do the following:

Before replacing a lamp, it is desirable to disable the battery minute. Then we need to open the luggage door, unscrew the additional carrots that contain the additional stop signal, and then click the top of his body

It is very difficult to replace the first generation of beep with the first generation. Before you start, you need to disconnect the battery minus, lift the front of the car, and install it on (better use the lift, if possible)

The individual settings for each driver in memory of Jeep Grand Cherokee WK2 are in this order: We turn the ignition switch to the position of ON.Cash on the driver's door button 1 or 2 (car allows to remember the settings for two drivers)

The first thing to do is disconnect the air patrons so they don't interfere with the work. Then the top of the generator arm should be removed by the key to 12. You need to remove the connector from the back of the generator that leads to the recharging relay