If a CHECK ENGINE lamp has been caught on the panel of Jill's devices, the engine control system has detected a malfunction. To determine this, you need to attach a diagnostic scanner (for example, the most popular of the OBD-II ELM 327 devices), connect it to a computer or a smartphone, and read ECU errors. Fault codes: 11-no error 34-EB.1 failure-zero result of detonation (failure) .15-high signal sensor output A. 16-high signal voltage A.C. 14-off of chain of DP.J. 61-off of circuit breakers controller. 24-branch circuit break.42-break of valve chain .17-high signal correction of parameters of jump. 35, 36, 37-high signal of self-learning.
- 11-no errors.
- 34 ECU failure.
- 1-zero detonation result (no failure).
- 15-high detonation sensor signal.
- 38-High frequency signal of the ACB.
- 16-branch circuit of the air pressure sensor.
- 14-Breaking down of the chain of command.
- The 61-edge of the idle governor.
- 19-Break of coolant sensor chain.
- 18-Breaking of the circuit of the air temperature sensor.
- 33-Exceation of maximum engine speed.
- 21, 22, 23, 24, breaking the chain of nozzles.
- 42 is the edge of the fan circuit.
- 17-the clipings of a lambda probe.
- 31-high input correction signal.
- 35, 36, 37-high signal of self-learning.
- 45-Failure warning signal chain.
- 25-edge of the adsorber valve chain.
- 13-The circuit breakers of the air conditioning unit temperature sensor.
- 43-Break of the gas distribution phase sensor circuit.