The coolant expansion unit (hereafter referred to as AW) is in the engine compartment. Turn off the engine and let it cool. Open the hood and check the level of the OB in the expansion box. The WAN level must be between "B" (MIN) and "A" (MAX). If the engine is heated, it may be slightly higher than "A" (MAX). If the OJ is not sufficient, the "temperature/coolant temperature/level" control lamp shall be used in a combination of devices.To put the rags on the cover of the expansion beacup and gently twist it to the oW.

  1. Turn the engine off and let it cool.
  2. Open the hood and check the level of oF in the expansion box.
  3. In the case of a cold engine, the WF level must be between the "B" and "A" (MAX). If the engine is heated, it may slightly exceed "A" (MAX).
  4. If the OJ is not sufficient in the expansion beam, the temperature/coolant temperature control lamp shall be set up in the combination.
  5. To put the rags on the cover of the expansion shirt and gently spin it off.
  6. Report to the OJ.
  7. Tend the cover to the specific clicks.
  8. Attention: not to mix AW-must be a single stamp.
  9. In the event of a lack of WW, to report clean water and, at the first opportunity, to fill the service center with water with concentrate in the desired ratio.
  10. For the dove, use only the new oJ.
  11. Do not pour OJ above "A" (MAX).
  12. The WW is heated through the overpressure valve in the expansion-unit cover from the cooling system.




Add comment

Security code
Refresh