In order to replace the oil filter R18A with the Honda Civil 8 Demonstrate the old oil filter by using a key to remove the oil filter (07HAA-PJ70100). Check the filter for the burnout of the rubber compaction on the saddle filter on the engine. Check the rubber gasket and rubber sealant of the new filter. Clear the seedling filter on the oil pan and put a thin layer of new oil on the rubber band of the filter. by the hand. Set up a rubber sealing ring and tighten the oil filter clockwise with a three-hour oil filter clockwise with the time of 12 Nm. If there are 4 marks on the outer surface of the filter (numbers from "1" through "4" or "6" for "6666"), perform the following procedure to filter the filter by hand until its sealing ring lightly turns to the surface of the oil cylinder's oil pan, and then mark the numerical label below. Rotate the filter by turning it clockwise to the three labels relative to the label below. For example, if at the bottom of the rubber sealant at the bottom is "6", drag the filter down until "6666" is below.
- Unmount the old oil filter by using a key to remove an oil filter (07HAA-PJ70100).
- Test the filter for the burnout of the rubber seal to the surface of the oil filter on the engine.
- Check the carvings and rubber sealant of the new filter.
- Clear the landing area on the oil pan and put a thin layer of new oil on the rubber sealing ring of the filter.
- Use oil filters only with the built-in oil re-entry system.
- Pull the oil filter out of your hand.
- Set up a rubber sealing ring and delay the oil filter clockwise using the oil filter by 3/4 rotations clockwise with 12 Nm.
- If there are 4 marks on the outer surface of the filter (figures from "1" through "4" or "6" for "6666"), the following procedure shall be followed for the filter to be applied.
- Manually trap the filter until the rubber ring on the rubber ring is slightly adjacent to the surface of the cylinder pan and then mark the numerical label below.
- Rotate the filter by turning the filter clockwise to the three labels relative to the label below. For example, if at the bottom of the rubber sealant at the bottom is "6", drag the filter down until "6666" is below.
