In order to replace the front shoes on Suzuki Grand Vitara II, a car should be raised by a jacks and placed near the rear wheel, after removal of the front wheel. Scroll down the two screws of the sub-port and remove the subport. Remove old pads, plates, and bolts. Clear the rails, remove the duster and clean the old grease, and then apply the new grease. Back the rails back. The working surface of the brake disc to be wiped with a soft cloth soaked in solvent. Teach the back of the shoe with the lubricant. Plate the plates on the pad and install the new pads. Lash the piston of the cylinder of the dry port by looking at the level of brake fluid in the bachka. Place the sub-port on the spot, lubricate the bolts, and tighten them up to 36 Nm. Teach the wheel back, remove the car from the jack. Repeat the same procedure for the second wheel. Start the car and press the brake pedal several times to make sure that the fluid level in the bachka is between "Min" and " Max". We have to remember that the first 400 km. The pads are titillating, so it's not a good place to slow down after they've been replaced.
