One of the problems of Toyota Avensis is the burnout of the reflector in the passing beam. The problem is solved by replacing the staff modules with new modules. To do this, you must: Roll 2 screws at the top of the headlight. Roll out 2 screws at the front of the front of the bumper. Detach the lower back of the bumper. Detach the sidewall of the bumper and remove the bumper. Remove the front fog-lamp and unplug the front-back of the headlight. The light. The new module and everything in reverse order. To install the glazing, use the glue-sealant.
- Scroll down 2 the upper anchorage bolts.
- Roll two smores under the covers.
- Remove the bolt from the bolt 2 from the top of the bumper.
- Roll out the mores of the lower plastic duster.
- Get the bottom of the bumper and clear the bumper.
- Remove the front fog lamps connector and disconnect the headlamps by closing it with a suitable bolt.
- Use the front-screwdriver to detach the lower anchorage of the headlights.
- Remove the headlamp.
- Warm the headlamp glass with a hairdryer (temperature approximately 75 to 80 degrees) for approximately 10 minutes.
- You can snort the glass and remove it.
- Roll out the 4 seams and remove the passing beam.
- Add a new module and gather everything in reverse order. To install the glazing, use the glue-sealant.
