Withdrawal and verification of the Lada Priora throttle position sensor

The Lada Prior LAP is a potentiometer, the output of which is a signal to the ECU about the angle of the throttle opening. The voltage of the sensor signal shall be changed from 0.6 B (the throttle completely closed) to more than 4.4 B (the lock is fully open). If the voltage is not equal to the voltage specified, the sensor is replaced. It is executed as follows: Detach the retainer, release the connector, remove the connector from the sensor, remove the connector from the sensor and remove the sensor.

1. Disconnect a minute from the ASB.
2. Press the retainer to remove the connector from the sensor.
3. Unwind 2 screws and remove the sensor.
4. Put the new sensor on, replace the powder seal with the powder, if necessary.