Procedure for the pumping of the Toyota Avensis power steering system 2: We check the level of the liquid in the bachka and if necessary, we're going to get the front part of the car. Without starting the engine, turn the steering wheel several times to the point where the engine starts and start the engine. After a few minutes of idling speed, a few times the rudder to the side of the vehicle is held in the last 2-3 seconds. We turn the engine off. Check the level of the liquid and check the level of the liquid, and we also find that no air bubbles are present.
- We're checking the fluid level in the bachka and, if necessary, we're milling it.
- Raise the front of the car.
- Do not start the engine, turn the steering wheel several times until it stops.
- Put down the car and start the engine.
- After a few minutes of engine operation at idling speed, a few times the cool rudder to each side, keeping the last 2 to 3 seconds in extreme positions.
- Shut the engine off.
- We're checking the fluid level, and we're also making sure there's no air bubbles.
