Procedure for replacing the rear beam siding with Jill MK: Put a car in a hole or a lift. Put emphasis on the wheel. We unwind the screw that connects the beam and the frame (the fuel filter can also be detached for ease of operation).The car is a little huddler, and the wheel of the beam stays on the ground.With the help of a hammer and a piece of chimney, we will knock off the rubber part of the site. With the metal nozzles, we put the metal part in the metal and also kick it out.
- Put the car on the hole or the lift.
- Setting the wheels on the wheel.
- You can unwind the screw that connects the beam and the frame (the fuel filter can also be detached for ease of operation).
- The car is a little huddler, and the wheel of the beam stays on the ground.
- With a hammer and a piece of pipes, we are leaving the rubber part of the site.
- Using the metal flushing the metal part of the metal, and also the metal part of the metal.
- Lubricating oil and press the new site.
- We repeat the procedure for the other side and collect it all back.