On the 4x4 birth of the fourth generation, the fourth generation, the rear suspension was installed. To replace the lever: We lift the lever arm and remove the mounting brackets. Pull the forward and rear bolts that attach the wheel bearing to the lever, and pull back the lever to the lower crossbeam. Pull the lever to the front transverse beam. Pull lever towards the forward crossbeam. The moment of the fastening of the pin to the transverse beam 10 Nm, the bolt pin to the rear beam 85 Nm, the attachment bolt to the bearing 169 Nm.
- Lift the car and take the wheel off.
- The lever arm shall remove the mounting elements of the ABS sensor arm and guide.
- Scrolls the front and back bolts of the wheel bearing the wheel bearing on the lever.
- Scrolls the lever to the bottom of the cross beam.
- Disconnect the spring from the brake pressure control.
- Scrolls the lever to the forward transverse beam.
- We're taking the lever.
- Set the lever in reverse sequence. The moment of the fastening of the pin to the transverse beam 10 Nm, the bolt pin to the rear beam 85 Nm, the attachment bolt to the bearing 169 Nm.
