- Details
-
December 10, 2021
-
Written by Jason Hance
In addition to the standard modes of ACPR (P-parking, N-neutral, R-reverse and D-normal traffic), the Toyota Land Cruiser 200 also has a mode of S
- Details
-
December 09, 2021
-
Written by Jason Hance
To change the oil in the front and rear differential TOYOTA CRUISER 200 need: (1) Remove Engine protection) 2) With the help of the 6-hedron, 10 \ mm unscrew the filler cap and remove the gaskets
- Details
-
December 07, 2021
-
Written by Jason Hance
The procedure for replacing the oil in the DTOYOTA LAND CRUISER 200 is as follows: (1) Install the car on level seal 2.) 2 screws and remove the damper of the valve (12 Nm at the back installation)
- Details
-
December 05, 2021
-
Written by Jason Hance
Before replacing the liquid in a Toyota Prius box, it is necessary to park the car on a smooth horizontal surface
- Details
-
December 03, 2021
-
Written by Jason Hance
To test the working fluid in the Toyota Prius, it is necessary to travel a little bit so that the liquid in the CV' s 70-80 C. After that, the car needs to be installed on a level floor and the parking brake is raised
- Details
-
December 01, 2021
-
Written by Jason Hance
Mode "B" is similar to "D" mode, but in this mode Prius starts to brake and power is not recovered into the battery
- Details
-
November 30, 2021
-
Written by Jason Hance
To replace the working fluid in ACPR with the Toyota Prius, you need to unplug the cork hole and drain the fluid. Then install a new gasket and twist the cork hole
- Details
-
November 28, 2021
-
Written by Jason Hance
You can check ACPR to RV-4 yourself (preferably on a free closed platform). The actions are as follows. Preheat the box to a working temperature of 50 to 80 C. This can be done in a car for a few minutes
- Details
-
November 26, 2021
-
Written by Jason Hance
The adjustment of the clutch is done when the height of the clutch is not in accordance with the standard:-For models with motor 2AD-FTV, 2AD-FHV-176.5 ... 186, 5mm;-For models with motor 1AZ-FE-169 ,2 ... 175, 9 mm;-For models with motor 2AZ-FE-177.9 ... 183, 9 mm
- Details
-
November 24, 2021
-
Written by Jason Hance
To check the level of oil in a distribution box it is necessary: (1) Remove the filler cap and the laying of the filler neck (located in the middle part of the carter's crater, from the side of the attachment to the CPP) .2) With the help of a finger or screwdriver, check the level of oil