Vehicle interior

Details

Written by: Jason Hance

Also available:

Created: 17 May 2023

This problem is common to all KIA RIo III, where the salon filter (grid) is installed. You can get rid of dust by installing a replacement paper filter.Order Filter Number-971332E200

Details

Written by: Jason Hance

Also available:

Created: 16 May 2023

The malfunction of the passenger's presence sensor is shown by the BMW 5 E60 control unit "thinks" that the seat of the passenger is permanently occupied. The problem can be addressed in several ways

Details

Written by: Jason Hance

Also available:

Created: 15 May 2023

A column filter in Chery Bonus is installed on the right side, under the toad (plastic panel in front of the windscreen)

Details

Written by: Jason Hance

Also available:

Created: 15 May 2023

Not all the owners of the KIA of Rio 3 can adapt to the peculiarities of the full-time magnet. Thus, for example, the KIA Rio III magnet begins to arbitrarily switch the radio station while working

Details

Written by: Jason Hance

Also available:

Created: 15 May 2023

The reason is the freezing of the throttle cable. When the engine is switched off, the throttle from the throttle shall be condensation that is later frozen

Details

Written by: Jason Hance

Also available:

Created: 14 May 2023

Some ZAZ production vehicles encounter an electrical installation error in the seat heating circuit: one of the wires has been placed on the reserve fuse (in the relay and fuses unit) without an electrical connection on the back

Details

Written by: Jason Hance

Also available:

Created: 14 May 2023

Stairs in KIA's Rio III driver's seat are the most commonly used for transverse and turning points

Details

Written by: Jason Hance

Also available:

Created: 13 May 2023

The "wrench" lamp on the dashboard is a maintenance light that triggers after the end of the service interval

Details

Written by: Jason Hance

Also available:

Created: 13 May 2023

The Chery Bonus car is fitted with a 2DIN magnet (with dimensions of 178x100 mm), but it is possible to install the 1DIN magnet if you wish, but for this it is necessary to use the filler that will occupy the remaining seat

Details

Written by: Jason Hance

Also available:

Created: 12 May 2023

To replace the column filter on Kia Sorento 2, you must do the following: 1. Teach the glove compartment opens and then push it inside. But don't dismantle it.