Vehicle interior

 The first thing to do is to open the gap-box. After this, unseat the fastenings on each side

The code for unlocking the Ford Focus 2 is located on its back end or in the car's glove compartment. If, for some reason, the code could not be found, you can use the code generation program that you can find on the Internet

The most common cause of intermittent (or permanent) power outages in the VAZ-2110 is its improper connection. In such a case it is instantly overheated and a red indicator light on it

That lamp says something's wrong with the gas tank. It may be poorly curled or worn and is no more leakproof. We need to reset the fuse and install a new cork.

In the first place, you need to spin off 6 self-service doors, 2 each with every door peat. Then it is necessary to unscrew the door closing handle by inserting a screwdriver from the bottom. After this, a blank filler is to be removed, and the two screws must be removed

It is difficult to determine the reason for the failure of a part of the VAZ-2110 heater to be difficult, but there are several typical cases that need to be diagnosed. It is possible that the wires are burned inside the controller-therefore they will need to be replaced

First, move the seat to the back and rotate the two bolts that hold it in the front. Then we need to move the seat forward as far as possible and rotate the two bolts that pin it to the floor at the rear of the vehicle.

It is very easy to remove the head restraint. There are plastic rings around the head-head of the head restraint. There's a protruing button on the right ring, and it's not on the left. It is necessary to simultaneously press both buttons (left-key or something like) and pull the head restraint up

According to the opinion, any modern speedometer "overestimates" the vehicle's speed by about 7-10% for security reasons. From this point of view, the onboard computer's readings are more accurate

On the Fokus the first generation has been installed a magnet of a very rare form factor-1.8 DIN. In order to remove it, it is best to use special tenants, but if they are not available, you can use nails or spokes of an appropriate diameter