- Details
-
March 15, 2023
-
Written by Jason Hance
To remove the seat cushion, remove the plastic molding on the seat hinges. To do this, you need to push the lock on the filler on the cover and move it forward. After that, the moan has to fall.
- Details
-
March 15, 2023
-
Written by Jason Hance
The salon filter is not installed on the Largeus, even in the most expensive installation, but there is a place under it. It is necessary to remove the front passenger's seat in order to work more easily
- Details
-
March 15, 2023
-
Written by Jason Hance
The first thing you need is a 21-wheel head of two bolts that secure the safety-belt buckles. Then, grasp the bottom of the seat back and pull it up. The back will be disconnected. Build in reverse sequence
- Details
-
March 14, 2023
-
Written by Jason Hance
If a gas pedal is idling, the problem can be solved by pulling the gas tracer. To do this, you need to open the hood, remove the clamp of the gas cable, and move the cover of the gas until the hatch is lost
- Details
-
March 13, 2023
-
Written by Jason Hance
The reason for the most common kidney failure is Lada Prior: The fan works only at 4 speed (without air conditioning). The reason is that the resistor's resistor is out of order
- Details
-
March 13, 2023
-
Written by Jason Hance
The Necsiah stove is not highly effective, it can be cold in the showroom. The problem may be solved by installing an additional electric pump from Gazelle. Pompeu has to be installed on the back tube of the heater
- Details
-
March 13, 2023
-
Written by Jason Hance
If the Necsiah is split or scroll, the head of the inlet to the cabin will have to completely dismantle the oven control unit and disassemble it. Most likely the cause of the breakage is a white plastic-limiter.
- Details
-
March 12, 2023
-
Written by Jason Hance
To remove the old handlebars (see para. (photo) on Lada Prior, we need to disconnect the minus cell battery and wait for about 10 seconds to release the capacitor. Then we insert two rods into the hole of the handlebar and push to remove the latches
- Details
-
March 12, 2023
-
Written by Jason Hance
If the air is much worse than the other, the problem is likely to be an untightness of air ducts
- Details
-
March 11, 2023
-
Written by Jason Hance
First, you need to remove the front seat that makes the creak. If the creak rests on the back, the seat can be removed-it is sufficient to remove the hull in the back of the back and lift it up