Vehicle interior

A pretty common problem with the Tiida, sometimes it's related to the operation of the control unit, which is under the glove box. The problem can be in the back contacts on the control unit, the test is better to trust a specialist

In Nissan Tiida, as in any other car, there are extraneous cricals, clatches and creaks, which act on the nerve of the owner

To remove the lining of the door, remove the plastic filler located behind the door opening and bolt the bolt. After that, we need to remove the chrome-cover of the door by gently touching it with a screwdriver. It is secured by the latches

The calibration of the released gas pedal position is the function of the ECM module, which is determined by the pedal sensor signal when it is completely released. The calibration shall be performed each time the disconnect of the pedal or ECM pedal transducer transaction is disconnected

Frequently, the contaminated ventilation system leads to poor air conditioning, a bad smell in the salon and cold-related disease. Therefore, the ventilation system needs to be cleaned regularly. The easiest method of cleaning is "contactless."

To activate automatic door locking at the beginning of the movement, activate the ignition, press the lock button of the central lock and hold it until it is clicked. After that, the doors will be closed automatically at 15-20 km/h

This is usually the case in the spring of X-Trail 2. The reason is the formation of the condensate and ice between the metal roof and its plating. More often than not, water flows through the windshield in the area of the front racks. The only solution is to install a roof-proofing noise

A glove box in Nissan X-Trail II will require LED tape and two-way tape. First, you need to roll out the eight self-actuals that the glove box holds, and get it. To install a dials in the glove box, you have to make a hole

The screwdriver makes a bar under the uphill of the seat, which is necessary for the stiffness. The bolts on this bar are waning and they begin to creak. It's necessary to put the bolts on the threads retainer and twist it, but not too much to prevent the threads from breaking

The replacement of the Nissan X-Trail II ashtray lamp will require the lamp itself (no-glass) and a screwdriver. The screwdriver must be removed and the front passenger's plastic filler removed. You can see the cap with the lamp.