To replace the rear brake pads on Skoda Yeti need: Remove the car from the car and remove the wheel. Attention, don't put the car on the brake!A "by 15" key to keep the rail of the guide fingers off and free the subport by twisting the two bolts "on 13" on the inside of the subport. Using the screwdriver, remove the old pads from the disc. Then remove the old pads from the rails. Clear the cover from the dirt and rust. Then roll the cover plate with the brake fluid. Press the back of the padding. (in kit).After replacing the pad, check the brake fluid level and twist the tank cover.
- Remove the car from the car and remove the wheel. Attention, don't put the car on the brake!
- With a "15" key, keep the grain of the sending fingers off and release the sub-port by twisting the two bolts "on 13" on the inside of the subport.
- Use a screwdriver to pull the pimp away from the disk.
- Then remove the old pads from the rails.
- Erase the details from dirt and rust and lubricate the rail-thin layer of stable grease.
- Then roll the cap off the brake fluid.
- Tash the port of the dry port and install it on the new pads.
- Insert new pads into the guides, drop the padding with the guide fingers, and roll with the new bolts with the time of 35 Hm (in the kit).
- After replacing the pad, check the brake fluid level and twist the tank cover.
Original: 1K0 698 451 J.
