Car body

Details

Written by: Jason Hance

Also available:

Created: 04 February 2022

If you don't work the rear door lock Reno Flüense, you can try cleaning it out. To do this: Remove the back door and a sealed back door. Let' s roll the back handle of the back door. Disconnect the slot 1 of the lock module

Details

Written by: Jason Hance

Also available:

Created: 03 February 2022

Especially often the lack of adjustment is caused by the cold (especially after washing) of the mirror. Helps in this case the heating of the car in warm parking, or warming of the mirrors with the help of the [ [ hairdryer]]

Details

Written by: Jason Hance

Also available:

Created: 03 February 2022

Such a problem is often observed at low temperature. The reason is that the language in the lock of the Renault Fluence door is on the water. The car is enough to open a little bit-and the door opens freely-closes

Details

Written by: Jason Hance

Also available:

Created: 02 February 2022

The Fluence label is glued to a double duct tape, so it doesn't make any trouble. And the Renault badge is kept on special fastenings, which then have holes on the surface of the body

Details

Written by: Jason Hance

Also available:

Created: 01 February 2022

If you want to replace the bonnet cable with Reno Flüense, do the following: Rise and remove front wheels. Remove the front wheel arches and front bumper. Remove the battery pack and the shelf

Details

Written by: Jason Hance

Also available:

Created: 31 January 2022

Perhaps the problem is not with the Renault Fluence door itself, but with its castle. There's dust in the lock on the door, and the creak comes in. To solve the problem, it is recommended to lubricate the castle with silicone grease

Details

Written by: Jason Hance

Also available:

Created: 30 January 2022

After the washing on the inner side of the back doors of the Renault Fluence, the water pods appear? In this case, it is desirable to contact the service: sometimes it turns out that the moulds are not glued, but simply inserted into a sealant

Details

Written by: Jason Hance

Also available:

Created: 29 January 2022

This is one common problem with Renault Fluence. The carpenters are failing (falling apart) because of the clips (clamps) in the rubber band. In order to correct this "failure", it is enough to "compress" the clips

Details

Written by: Jason Hance

Also available:

Created: 29 January 2022

The VIN in the Renault Fluence is taken out on the floor under the carpeting in the front of the body. It's easy to detect if you push the right seat. The Renault Fluence engine number can be seen at the front of the cylinder block, near the box

Details

Written by: Jason Hance

Also available:

Created: 28 January 2022

In hot summer weather, there is a strong noise in the open rear windows. The higher the speed, the stronger the hum. This is the aerodynamics of Renault Fluenc (similar to the Renault Megan II). At high speed, it's the air flow. If front windows are open, no noise