Car body

Unlocking the door handle Reno Flüens in this sequence: Pull the lock of the door lock (a suitable device will be needed to record the cylinder inside the door)

We take off the side moldings on the doors of Reno Flüense in this order.

Procedure for removing the exterior mirror on Reno Flüense: The interior decorative lining of the mirror is removed from the cabin. The mirror connector is disconnected from the interior of the mirror 2

To remove the rear bumper Reno Flüens, you need to lift the car and remove the rear wheels.

The glass can be cracked by the wrong gluing when it goes into the frame (s). The body starts to "play" on unevenness-glass cracking. In this case, it is to be replaced by the guarantee

There is a small ventilation hatch under the right side of the plating in the trunk. It is mounted on the four latches (two from the top, two from the bottom). About the hatch, most likely, and maybe water pumping. The reason is a very weak gasket

With the locking of the lock of the boot door on Reno Fleurens, you can try to remove it and repair it. To do this: If the boot door does not respond to electronic opening, manually unlock it from inside the passenger compartment with the screwdriver

To change the mechanism of a manual window lift to Reno Flüense, do the following: Take off the appropriate door and its hermetic films. Unwind the rear speaker. Open the window by half

To remove the front door delimiter on Reno Flüense, do the following: Take the door upholstery and front speaker.

The order of removal of the front sub-wingers on Reno Flüense: Pull the car up and remove the front wheel.