- Details
-
January 11, 2022
-
Written by Jason Hance
The most common reason for the creaking of the Peugeot 206 is the wear of the generator's pulley. The resource of this feature is about 80,000 kilometers. In this case, the replacement of the worn out part must be repaired
- Details
-
January 10, 2022
-
Written by Jason Hance
Since 2001, Peugeot 206 has been used instead of a normal transaction, a multiplexed, significantly reduced number of wires. This transaction is characterized by parts of a failure that may result in incorrect operation of the car's electrical equipment
- Details
-
January 09, 2022
-
Written by Jason Hance
To remove the JSCB on Peugeot 207, it is necessary to: 1. Remove two plastic covers mounted by the latch; 2. Detach the bolt (key 8) holding a second cell and detach it; 3. Raise the red flag up and detach the plush clamp; 4
- Details
-
January 09, 2022
-
Written by Jason Hance
You'll need a thin screwdriver, preferably "sentry", to remove the cap of the Peugeot 207. To remove the cap, lift the lid of the boot to the eye level. Then gently insert the screwdriver into one of the holes located on the sides
- Details
-
January 08, 2022
-
Written by Jason Hance
As practice shows, it is possible to install the glove box if the Peugeot 207 is not available. In order to check if this is possible, remove the plastic filler at the place of the backlight.
- Details
-
January 08, 2022
-
Written by Jason Hance
After 30 minutes of downtime, the Peugeot 207 control system automatically disconnects all additional electrical equipment (energy saving mode)
- Details
-
January 07, 2022
-
Written by Jason Hance
If the glass washer and the fluid in the car of Peugeot 207 went out of the windshield, the first thing to do is check the level of cleaning fluid in the baker
- Details
-
January 06, 2022
-
Written by Jason Hance
To replace the Peugeot 207 lamps, the full removal of the lamp must be removed. It is easy to do this: 1. Open the door of the luggage compartment and remove the blank filler at the lantern level; 2. Disconnect the pad from the wire; 3
- Details
-
January 06, 2022
-
Written by Jason Hance
Frequently the owners of Peugeot 207 with engine 1.4 and PPC 2-Tronic note the stereotype problem: the engine does not start-the starter does not spin, the display blinks "Auto" and instead of the letter "N", two worms are displayed. These symptoms point to a low battery charge
- Details
-
January 05, 2022
-
Written by Jason Hance
The closing function at the beginning of the movement is implemented in all Picugs of Peugeot 207. To activate automatic locking, you must press and hold for 2 seconds. lock button on the central auto panel