Electrical equipment

The following lamps are suitable for the Opel Corsa D:-Driving beam: H1, 55 W, 12 V 2098279.-Passing beam: H7, 55 W, 12 V 2098928

The modes of operation of the headlamps to the Opel Vektra C are chosen according to the loading of the vehicle and the design of its suspension: For models without a tracking system, the clearance is:-position 0-Front seats occupied.-Position 1-all seats occupied

The On-board computer Opel Vektra C can display the following warning messages:-Remote Control/Battery check-low battery key battery.-Brakelight/switch check-no stop lamps burn.

Once the battery is shut down or in other cases, the power trap on the Opel Vetra C is to be resynchronized by: 1) Turn on the ignition. 2) Press the hatchway switch until it is completely closed and is holding for three more seconds

Remove the generator from the engine at (X16XEL) in the following order: (1) Disconnecting the electrical wires of the generator) by removing two screws from the head "by 15" .3) by removing the three bolts of the head "by 15"

For all modifications of Peugeot 206 with petrol engines, batteries with a length of 207 mm, a width of 175 mm and a height of 190 mm are suitable. Polarity must be reversed. Peugeot 206 with a 1.1 litre engine needs a battery with a capacity of 45 to 55 A/h. If the engine is 1

Many model owners are thinking about installing the onboard computer on Peugeot 206. The problem is finding an appropriate computer that is compatible with the model is hard to find.

The trunk of the trunk in Peugeot 206 is under the skin and is fixed to the left center of the door. The trailer is responsible for enabling the luggage compartment and also sends a signal to the central lock

For Peugeot 206, the Sagem SL96 Electronic Engine Management Unit has problems with idle speed, rods, and misfiring. This behavior of the engine can talk about the failure of the control unit's electronics

The Peugeot 206 sound electrical circuit should be started from the circuit breakers. If the fuse that matches the sound is not overblown, then the reason is in the broken wire of the line going to the horn