Electrical equipment

If Nissan Tana does not operate the hatch, then do the following: (1) Try to close the hatch by holding the switch in the CLOSE.2 position) Continue to hold the switch for 10 seconds

In some cases, Nissan Teana may have an increase in idling speed whenever the headlamp or other power consumers are switched on

Xenon lamps are best placed to change at the service station, as there is a risk of a high voltage current. With halogen light bulbs, Nissan Teana is easier. To change them: Disconnect the wire from the battery

This effect is produced by poor disc quality (scratches and rubbing)

To eliminate the whistle, sometimes it's enough just a little bit of the generator belt. If this action does not help, you can process the silicon spray

When locking a magnet, you must enter the code that is issued when the new car is sold. Such code can also be obtained from official dealers-they remove the tape recorder, write off the factory number and send a request to the European representation

Sometimes there is a need to close the parked car outside. To do this, you need to get out of the car without locking the driver's door, blocking the central lock. Then you need to pull the handle of the door on yourself and, not leave it, close the door. Target will be achieved

To access the bleach, either remove or dismount the front wheel cover. The washer is secured by two metal clips: one is above the second. The upper hold is held by the heater itself, and the lower end of the washer

To dismantle the magnets, it is necessary first of all to remove the plastic protectable linings of the magnet. It's holding on to the latches, which are easy to break, so you need to take it very carefully.

All Nissan X-Trail 2 picks have this function. To activate it, it is necessary to blink the main beam every time after the ignition is switched off. The single blink lights the lights for 30 seconds, each for an additional 30 seconds.