Electrical equipment

If the Nissan Nissan Cashdo's 2nd generation burned down the passing/driving lamp or the counter-beam, it must be replaced. However, it is necessary to purchase a new lamp according to the manufacturer's recommendations

 The Nissan external temperature sensor on the first generation of Nissan is attached to the radiator and attached to the radiator. You can get to it by using a bonnet lock or lifting the grille. Next, disconnect the power connector from the sensor

Many owners of Nissan Kashkai of the first generation collide in front of the car at the start of traffic, at about 10-15 km/h. One loud click could be heard, and some five deaf stunts were heard. These sounds do not indicate a problem

Owners of Nissan Caskai 1st generation have often wondered about the installation of daytime running lamps on their car. In 2010, Nissan Qashqai's market was removed from the market.

Before you start, you need to turn off the minus-minus.

The first thing you need to do is disconnect the minus cell phone.

Replace the lamps of the position lamp and the lamp of the Nissan Kashkai turn-indicator lamp is not falsely

The self-diagnosis regime for Nissan Teana is the second operating mode. By default, the system of on-board self-diagnosis operates in a failure alert mode. To switch to the second mode and read the error codes: Turn the ignition on to the ON position

The smart key system on Nissan Teana allows you to switch on by pressing the button, opening the doors, and the boot with the Intelligent Key key. The system's action radius is limited. To start the engine with a button, the key must be in the car's car

If the electrical elevators in the Nissan Tana do not operate in an automatic closing mode, they must be set up