- Details
-
May 04, 2022
-
Written by Jason Hance
The ninth generation Lancers of the ninth generation were equipped with [ [ shaded]] lights: the inner part (around the reflectors) was black, creating the effect of a shaded lamp but did not affect the quality of the road illumination
- Details
-
May 03, 2022
-
Written by Jason Hance
If the lights turn out when the doors are opened in the passenger compartment, you need to check the position of the power-off switch: the light may be off completely. If the lever is in the right position, the fuses and trailers must be checked in the doors
- Details
-
May 02, 2022
-
Written by Jason Hance
Laser-lifts do not work with ignition off. They continue to operate immediately after the ignition is switched off for 30 seconds and then disconnect
- Details
-
April 30, 2022
-
Written by Jason Hance
A small flat-blade screwdriver will be required to adjust trout. It needs to be inserted in the nozzle and left-right-to-right-up-to-bottom-up-down-to-the-nozzle hole
- Details
-
April 29, 2022
-
Written by Jason Hance
Before you begin the repair process, you need to ensure that the dashboard is functioning properly. To do this, take a simple test: turn off the ignition and remove the connector from the fuel level sensor and then switch the ignition switch to the ACC position. Sensor should show full tank
- Details
-
April 28, 2022
-
Written by Jason Hance
You will need a Phillips screwdriver to remove the dashboard. In the first place, you need to unroll the two top carroes. After this, detach the plastic lining and untwist the 3 carroches that attach the dashboard
- Details
-
April 27, 2022
-
Written by Jason Hance
This indicator is on the Lancers with a 2-liter engine, 1.3 and 1.6 liters. But you can install it yourself. To do this, you need to remove the dashboard. Remove the cover from the rear of the dashboard (it is held on four mores)
- Details
-
April 25, 2022
-
Written by Jason Hance
The installation of xenon lamps into light devices not certified for this is prohibited by road traffic regulations. However, it is not difficult to technically do so. The first thing to do is to remove the duster for the anti-drugs and the anti-monk
- Details
-
April 24, 2022
-
Written by Jason Hance
The Lancer's lobster is not working very well, so they can be replaced by the wind-screen injectors from Mitsubishi Galant 2008 of the model year. You can also install hoses from Galant: they already have a built-in non-return valve
- Details
-
April 23, 2022
-
Written by Jason Hance
The point is that the environmental temperature sensor has a temperature limit. This is not a malfunction. If the sensor is not functioning, the on-board computer will display a dash instead of the temperature