- Details
-
April 09, 2022
-
Written by Jason Hance
To replace the passing lamp, you must open the hood, disconnect the connector from the headlamp, remove the rubber cap, remove the spring and remove the burnt lamp. To simplify the installation of a new lamp, remember the orientation of the old lamp
- Details
-
April 08, 2022
-
Written by Jason Hance
The work should be carried out on a well-warmed car, as cold plastic becomes very fragile and increases the likelihood of breaking plastic anchorages and pitons
- Details
-
April 07, 2022
-
Written by Jason Hance
The user's guide indicates that the warmup, in raw weather, and when the temperature is overtaken does not indicate a malfunction or depressurization of the headlamp. Mortgage is disappearing after passing with the passing beam (the headlamp is warmed up)
- Details
-
April 05, 2022
-
Written by Jason Hance
You can. To do this, after the engine is plugged, first turn off the lights and then switch the ACPR selector to the position of the included dimensions. The car can then be closed and the position lamps will be switched on
- Details
-
April 04, 2022
-
Written by Jason Hance
Statistically, most of this type of malfunctions (a sign, a sensor, etc.) are more likely to be related to the incorrect installation of additional electrical equipment (immobilizer, alarm, etc.)
- Details
-
April 03, 2022
-
Written by Jason Hance
There is no fault in this case: the counter-manic and shall only burn on the left side. This is not unique to Mitsubishi, but also for other brands
- Details
-
April 02, 2022
-
Written by Jason Hance
To remove Mitsubiši Padero 4 to switch the lamp in it is easy. To remove the Mitsubishi Pajero IV, you need to do the following: To remove the headlights, Pajero has to remove the grille that is attached to the bottom of the rack.
- Details
-
March 31, 2022
-
Written by Jason Hance
Calibration of the compass on Mitsubishi Padero 4 must occur automatically. If the meter reading is not displayed, then you need to do your own setup
- Details
-
March 30, 2022
-
Written by Jason Hance
There are 13 levels of brightness for daylight and late-night lighting for the Mitsubishi Pingero. To set them up: 1) Turn on the position lights or the passing-on. 2) Push the ADJ button
- Details
-
March 29, 2022
-
Written by Jason Hance
One of the reasons for the failure of the hatch in Mitsubishi is the operation of the Injury system. If there is a foreign object when the hatch is closed, the system automatically opens the hatch