- Details
-
March 28, 2022
-
Written by Jason Hance
Headlamp on Mitsubishi Padero 4 should be installed in the following provisions depending on the loading of the car:-Position 0-in the passenger compartment only the driver or the driver + front passenger
- Details
-
March 26, 2022
-
Written by Jason Hance
The fuse box is located in Mitsubishi Pajero 4, to the left of the steering column
- Details
-
March 25, 2022
-
Written by Jason Hance
Mijubishi Pajero 4 with 6G75 engine allows to read cruise control errors without a scanner. To do this: (1) Turn the system switch to the COAST/SET.2) switch to the position of ON.3)
- Details
-
March 24, 2022
-
Written by Jason Hance
The [ [ Parktronik]] in [ [ Mitsubishi Padero]] responds to the approach to the obstacle with the following audible signals: Angular sensors:-Interrupting signal-distance from 40 to 50 cm.-Frequent Intermittent-Distance 25-40 cm.-Continuous signal-less than 25 cm
- Details
-
March 23, 2022
-
Written by Jason Hance
To set the cruise control rate on Mitsubishi Pajero 4, you need to do the following: 1) Press ON/OFF Cruise Control on the handlebar. The CRUISE lamp must be lit. If it does not burn, press ON/OFF also 2) Increase the speed to the desired speed and press the COAST SET button
- Details
-
March 21, 2022
-
Written by Jason Hance
To replace the front fog lamp with the Mitsubishi Padero 4, you need to do the following: 1) A screwdriver with a flat plate, and remove the three retainer retain.2 (2))
- Details
-
March 20, 2022
-
Written by Jason Hance
If there is a broken glass of fog-lamps on the Mitsubishi Padero 3, it doesn't have to change the whole faro.
- Details
-
March 19, 2022
-
Written by Jason Hance
It is not difficult to find a salon block of fuses in Nissan Almer Classic, it is located at the bottom to the left of the steering column and is closed by a special lid. The exterior of the closed circuit breakers in Almera Classic is similar to a mini-bar from the driver's side
- Details
-
March 18, 2022
-
Written by Jason Hance
If Nissan Almer Classic overlights the passing lamp, it can be easily replaced with one's hands
- Details
-
March 16, 2022
-
Written by Jason Hance
A rowing transaction near the headlights is a common problem for Nissan Almera Classic. The consequences could be the melting of plastic elements of the headlamp and even ignition. The problem can be solved by replacing or installing xenon lamps