- Details
-
February 11, 2022
-
Written by Jason Hance
To activate a function, you must press and hold the 5 seconds locking and opening buttons at the same time. The mode is also disabled. Once the mode is activated, the single click will open only the driver's door, and all at two times
- Details
-
February 10, 2022
-
Written by Jason Hance
If the hatch on the roof is not opened or closed automatically, it shall be calibrated. 1. Close the floor hatch. Press the "STAR" button-the hatch will rise. Let go of the button.3. Press the "PAYNE" button again and hold it until the hatch is completely closed
- Details
-
February 10, 2022
-
Written by Jason Hance
Nissan X-Trail 2 lanterns are very large and their upper segments are deprived of lamps. This provides extensive opportunities for upgrading. In the first place, you need to unmount two screws on each bolt and release the latches
- Details
-
February 09, 2022
-
Written by Jason Hance
The X-Trail 2 bleach is triggered by every click on the windshield washer button. Because of this, the consumption of the liquid is increasing. There are two ways to solve the problem. The first is the most radical-disabling the headlight
- Details
-
February 08, 2022
-
Written by Jason Hance
A fairly common problem with the Nissan X-Trail of the second generation-the broken automatic mode of glass lifting-has to be held by the button.
- Details
-
February 08, 2022
-
Written by Jason Hance
The battery type is specified according to the Japanese JIS standard. For the example, you can use 70D13L marking: 70 is the capacity of the battery. This number does not indicate the capacity in ampere hours as adopted in Europe, but is an integral characteristic that takes into account the capacity and current of the cold start
- Details
-
February 07, 2022
-
Written by Jason Hance
If the car is equipped with a xenon headlamp, it is necessary to contact a service center, as the lamps are high voltage. If the car is equipped with halogen lamps, they can be replaced independently
- Details
-
February 07, 2022
-
Written by Jason Hance
It is not difficult to independently replace the automatic gearbox. To begin with, you need to unwind the bolts retaining the back of the side panels of the central tunnel. After that, remove the bolts of the gearbox
- Details
-
February 06, 2022
-
Written by Jason Hance
To install the rear seat heating, you will need to purchase several universal heating sets, connect them together, remove the rear seat, remove the cover, pack the heating, connect to the boot jack
- Details
-
February 05, 2022
-
Written by Jason Hance
The main advantage of the [ [ Intelligent Key Key]] is that it is not necessary to get it out of the pocket for access to the car and to start the engine