Electrical equipment

Maintenance intervals can be changed. You can also completely disable this feature in the onboard computer. You have to press, hold, and release the button four times. After each hit, the audible alarm will be heard, and then the text "EU10" appears on the screen

There's a jumper on the S-230, the removal of which won't allow the car to be started. If the jumper is replaced by a hidden switch, this can be an additional anti-theft device. No errors are displayed when setting the check box

Many Mitsubishi ASX owners believe that the rain sensor is not working correctly-it is either too sensitive or vice versa. It is not known to all that his sensitivity can be regulated

The factory multimedia system Mitsubishi ASX does not allow you to view video during motion. The prohibition is dictated by security conditions. But many on their fear and risk wish to release the lock

The installation of a cleaning fluid level sensor is not an easy task. It includes both mechanical and electrical interferences. Execution of works requires some experience and knowledge. First of all it is necessary to purchase the sensor itself

It's not that hard to install a parkron. The ideal height for installing sensors is 50-55 cm above the ground. For the correct orientation of the sensors along the bumper, it is necessary to attach a small tape. First of all it is necessary to remove the plastic pallet of the trunk, pulling it up

Installing the buttons on the handlebar is not a very complicated procedure.

The factory trout of the Mitsubishi ASX circuit has two separate nozzes, so many of them change them to the windscreen of Volvo, which better clean the glass from the mud. It should be remembered that the Volvo is not adjustable

The stabilization system may be installed at Mitsubishi ASX, which is not equipped at the plant, but it will require a lot of rework and experience, as well as a whole list of details and consumables

To replace the glass of the fog lamp, the front fog lamp itself should be removed and the front fog lamp shall be heated as the glass pane is heavier. Use hot water to warm up