- Details
-
April 22, 2022
-
Written by Jason Hance
This is not a malfunction. The illumination of the illumination is provided for the bright illumination to not distract the driver from the road at night
- Details
-
April 20, 2022
-
Written by Jason Hance
There are two red translucent plastic inserts in the rear bumper of the lancer Landser. The left is a "anti-manic", and the right is a simple reflector, there is no lamp. These pits are often stolen
- Details
-
April 19, 2022
-
Written by Jason Hance
The replacement will require the original lamps, which are not easily found on the market. First, remove the block of dimmer, then the unit corrector unit. There are holes in the blocks under the lamp, and you do not need to understand the units. The lamps are fitted with light filters that are easily torn
- Details
-
April 18, 2022
-
Written by Jason Hance
A flat-blade screwdriver will be required to replace the illuminating lamp on the Lanser sedan. First of all, we need to remove the trunk lining. It is embedded with plastic pitons under a Phillips screwdriver.
- Details
-
April 17, 2022
-
Written by Jason Hance
Instead of burning lamps in the button, it will be possible to supply LEDs. You can get a block of buttons with a thin, splashy screwdriver. It is held in four latches, two each on the side of each seat
- Details
-
April 15, 2022
-
Written by Jason Hance
The first thing to do is to remove the expansion tank with a cooling fluid. The lamps are removed after turning, counterclockwise, 90 degrees. The lights of the position lamps are not cool, they can be removed simply by pulling on themselves
- Details
-
April 14, 2022
-
Written by Jason Hance
In order to replace the lamp with the number light, a Phillips screwdriver should be turned off at the edges of each plaid and the lens removed. After that, you can pull out the cartridge and replace the lamp
- Details
-
April 13, 2022
-
Written by Jason Hance
To replace the front lighting lamp, the Lancer X needs a flat-blade screwdriver to the front of the front or rear of the front and pull down. To access the rear-plug lamp, it is necessary to use the same screwdriver from the button side and pull it down
- Details
-
April 12, 2022
-
Written by Jason Hance
The forecasters Mittushi Lanser 10 is located on the trunk lid and on the wing of the car. Depending on where the lamp is located, it varies
- Details
-
April 10, 2022
-
Written by Jason Hance
4 light bulbs that are in the climate control block are often burned. In order to replace them, the Mitsubishi MR444536 light bulb and the screwdriver are required. In the climate control unit, you need to twist two mores.