The throttle control over the Mono-Motronic system is checked as follows: Disconnect the controller connector to connect the potentiometer voltage with a voltages of a 4.5 volt battery or a 6-volt charger. If the connector is 4-pole, the contacts that you want are 1 and 2, if 6-pole, then 1 and 6. The caterer shall move completely. The pole of the connecting wire (minutes contact at the top contact pin) is changing. The push rod shall be fully actuating the support engine's winding resistance-it must be between 3 and 200 Ohm.
- Detach the controller outlet.
- Connecting the potentiometer voltage with a voltages of a 4-volt battery or a 6-volt charger. If the connector is 4-pole, the contacts that you want are 1 and 2, if 6-pole, then 1 and 6. The shot's got to hit the wall.
- Change the pole of the connecting wire (minutes contact at the top contact pin). The shot must be fully advanced.
- The resistance of the auxiliary winding of the auxiliary engine shall be between 3 and 200 ohm.
