In order to replace the oil in the control system of the body of the Mercedes S-Class (W221), it will be necessary to use the STAR Diagnosis scanner. The procedure is as follows: I turn the scanner off and we make a short test for errors. If necessary, clean them up. Start the engine and let it work on idling speed. In the scanner, we select "Cyclically changing the activation of cushioning frames in the circle" and run the program (approximately 15 minutes). So we're going to warm up to 80 degrees. We turn off the engine. We disconnect the reverse hose from the FAC and send it to the appropriate capacity. Remove the tank cover, remove the filter, and then turn the cover back on. Start the engine and select "Activation" and "Cyclic activation of the front and rear shock absorbers." The auto-start program must be alternately raised by the front and rear of the bridge, followed by the oil level in the bachet and periodically through the control hole. We use around 10 litres of oil to wash the system. We turn the engine off and put it all back.

  • I turn the scanner off and we make a short test for errors. If necessary, clear them.
  • Let' s start the engine and let him work on the idling speed.
  • On the scanner menu, select "Cyclically changing activation of cushioning frames in circle" and run the program (approximately 15 minutes). Thus, the oil will warm up to 80 degrees.
  • Shut the engine off.
  • Disconnect the inverse hose from the FAA expansion beam and direct it to the appropriate capacity.
  • Remove the cover of the tower, remove the filter, and back the cover again.
  • Start the engine and select "Activation" and "Cyclic activation of the front and rear shock absorbers" on the scanner menu. The front and rear of the bridge should be alternated between the front and rear of the vehicle.
  • Watch the level of oil in the tank and periodically pour it through the control hole. We're using about 10 litres of oil to wash the system.
  • Turn off the engine and put it all back.




Add comment

Security code
Refresh