The removal of excessive Luft in the Aaudi 100 P4 steering mechanism can be done by the following procedure: The assistant must spin the steering wheel a little. At the same time, under the hood of the adjuster bolt (located between the brake amplifier and the engine compartment) and roll it up until the knocking and the rattling are taken. The steering wheel shall be rotated freely and without extra effort. If necessary, rotate the steering wheel. If it does not help, it is likely that the steering equipment is most likely to be replaced.
- Put the wheels straight.
- The assistant should rotate the rudder slightly from side to side. In this case, under the bonnet, find the adjustment bolt (located between the brake amplifier and the engine compartment) and shall be rounded until the bolt and the jitter is lost.
- By making a test trip and verifying the correctness of the installation, the rudder shall rotate freely without extra effort.
- If necessary, turn the bolt to 15 degrees and check the rudder again.
- If adjustment has not been possible, it is likely that the steering equipment is likely to be replaced.
